Other functions
Heated handgrips (not available in this version)
This function allows enabling and adjusting the
heated handgrips: this function is active only if the
heated handgrips are installed.
The heated handgrips kit can be purchased separately
at a Ducati Dealer or Authorised Service Centre.
To enable the "H.GRIPS" control menu for the heated
handgrips, press the Start button (5) on the RH
switch.
Note
The Start button (12) controls the heated
handgrips only when the engine is running.
The display layout could be of two types:
-
with Menu 2 enabled (Fig. 85);
-
with Menu 2 disabled (Fig. 86);
Once the menu is activated, press the same button
several times to select the desired indication ("OFF",
"LOW", "MEDIUM" or "HIGH") which becomes bigger.
If "OFF" is selected and bigger, the heated handgrips
are switched off.
If "LOW" is selected and bigger, the heated handgrips
are activated in their lowest setting.
If "MEDIUM" is selected and bigger, the heated
handgrips are activated in their intermediate setting.
If "HIGH" is selected and bigger, the heated handgrips
are activated in their highest setting.
Select the desired setting then leave button (5)
undisturbed; after 3 seconds with no controls, the
instrument panel automatically quits the indication
and maintains the last stored condition.
When quitting the handgrips setting menu, the
instrument panel warns the user if heated grips have
been activated by turning the specific icon yellow (at
the top RH side if Menu 2 is enabled or at the top LH
side if Menu 2 is disabled), and showing the setting
("LOW", "MEDIUM" or "HIGH").
138
Содержание Diavel 2014
