Ducati DCS 5500R, Руководство пользователя

Страница: 45 / 52

DCS 5500
45
English
Owner’s manual
Place your file on the cutter and push straight forward. Keep the file position as illustrated.
Type of chain
File diameter Top plate angle Down angle
Head tilt angle
(55°)
Depth gauge
standard
Vise rotate
angle
Vise tilt angle Side angle
72V 7/32” 25° 10° 60° 0.025”
Depth gauge
File
Guide bar
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
WARNING
The table contains a list of all possible combinations between bar and chain, indicating
those which may be used on each machine, marked with the symbol “*”.
Pitch Guide bar Chain
Zoll
Length
Inches/cm Groove width
Inch./mm
Code Oregon
Number of
nose teeth
Code Oregon
Number of
drive links
0.325” 16”/40cm 0.058”/1.5mm 168PXBK095 10 21BPX066X 66
0.325” 18”/45cm 0.058”/1.5mm 188PXBK095 10 21BPX072X 72
0.325” 20”/50cm 0.058”/1.5mm 208PXBK095 10 21BPX078X 78
For replacement use only above bars and chains. If you use non‐approved combinations it may cause
serious personal injury and damage to the machine