Ducati DCS 5500R, Руководство пользователя

Страница: 44 / 52

DCS 5500
44
Owner’s manual
English
Saw chain
WARNING!
It is very important for smooth
and safe operation to keep the cutters always
sharp.
Your cutters need to be sharpened when:
• Sawdust becomes powder‐like.
• You need extra force to saw in.
• The cut way does not go straight.
• Vibration increases.
• Fuel consumption increases.
Cutter setting standards:
WARNING!
Be sure to wear safety gloves.
Before filing:
• Make sure the saw chain is held securely.
• Make sure the engine is stopped.
• Use a round file of proper size for your chain.
Chain type: Oregon 21BPX
File size: 3/16” (4.8mm)
Place your file on the cutter and push straight
forward.
Keep the file position as illustrated.
After every cutter has been set, check the
depth gauge and file it to the proper level as
illustrated.
Be sure to round off the front edge to reduce
the chance of kickback or tie‐strap
breakage.
Make sure every cutter has the same length
and edge angles as illustrated.
(1 Fuel filter)
(b) Disassemble the filter and wash with
gasoline, or replace with a new one if
needed.
IMPORTANT:
• After removing the filter, use a pinch to hold
the end of the suction pipe.
• When assembling the filter, take care not to
allow filter fibers or dust inside the suction
pipe.
3. Spark plug.
Clean the electrodes with a
wire brush and reset the gap to 0.65 mm as
necessary.
4. Sprocket. Check for cracks and for
excessive wear interfering with the chain
drive. If the wearing is found obviously,
replace it with new one. Never fit a new
chain on a worn sprocket, or a worn chain
on a new sprocket.
(1) E‐ring
(2) Washer
(3) Needle bearing
(4) Clutch drum
5. Front and Rear absorber spring.
Replace
if spring is deformation. Use only the spare
parts which listed in this manual. Use the
other spare part can cause serious injury.