Ducati DCS 5500R, Руководство пользователя

Страница: 43 / 52

DCS 5500
43
English
Owner’s manual
2. Oiling port
Dismount the guide bar
and check the oiling port
for clogging.
(1) Oiling port
3. Guide bar
When the guide bar is dismounted, remove sawdust
in the bar groove and the oiling port.
Grease the nose sprocket from the feeding port on
the tip of the bar.
(1) Oiling port
(2) Grease port
(3) Sprocket
4. Others
Check for fuel leakage and loose fastenings and
damage to major parts, especially handle joints and
guide bar mounting. If any defects are found, make
sure to have them repaired before operating again.
Periodical service points
1. Cylinder fins. Dust clogging between the
cylinder fins will cause overheating of the
engine. Periodically check and clean the
cylinder fins after removing the air cleaner
and the cylinder cover. When Installing the
cylinder cover, make sure that switch wires
and grommets are positioned correctly in
place.
2. Fuel filter.
(a) Using a wire hook, take out the filter from
the filler port.
it stops completely. Wear the safety glove
and remove the barrier. If the chain must
be removed, please follow the instruction of
relevant part like installation in manual. A trial
run must be conducted after the cleaning and
newly installation. If vibration or mechanical
noise is discovered, please stop the use and
contact your dealer.
8. MAINTENANCE
WARNING. Before cleaning, inspecting or
repairing your unit, make sure that engine has
stopped and is cool. Disconnect the spark plug
to prevent accidental starting.
Follow the instructions to carry out regular
maintenance, pre-operating procedures
and daily maintenance routines. Improper
maintenance may result in serious damage to
the machine.
Maintenance after each use
1. Air filter.
Dust on the
air filter surface can be
removed by tapping a
corner of the filter against
a hard surface. To clean
dirt in the meshes, split
the filter into halves and
brush in gasoline. When
using compressed air,
blow from the inside. To
assemble the filter halves,
press the rim until it clicks.