DSC 3G3070, Руководство по установке

Страница: 13 / 24

9
Events description
Customer Code - type in a 4 character code (accepted values: digits and the letters A, B, C, D, E and F).
Event Code - type in the Contact ID to be transmitted when the respective event occurs.
Send - select (tick) the events to be sent.
See the ‘Operating Principles’ section of this manual for default contact ID events.
Contact ID Default
Click on this button to assign the following event codes to the events managed by this device.
Event Description Event Code Central Station Description
Input 1 Activation E 110 Fire Zone 001
Input 1 Restoral R 110 Fire Zone 001
Input 2 Activation E 120 Panic Alarm Zone 002
Input 2 Restoral R 120 Panic Alarm Zone 002
Input 3 Activation E 130 Burglary Zone 003
Input 3 Restoral R 130 Burglary Zone 003
Input 4 Activation E 150 24 Hour Zone 004
Input 4 Restoral R 150 24 Hour Zone 004
PSTN Line Down E 351 Telco 1 Fault 000
PSTN Line Restoral R 351 Telco 1 Fault 000
12V Input Loss E 337 Exp. Mod. DC Loss 000
12V Input Restoral R 337 Exp. Mod. DC Loss 000
Low Battery Alert E 338 Exp. Mod. Low Bat 000
Low Battery Restoral R 338 Exp. Mod. Low Bat 000
Periodic Report E 603 Periodic RF Xmission 000
Cellular Unit Activation R 552 Radio Xmitter Disabled 000
Cellular Internal Buffer Full E 624 Event Log Overflow 000
FTC Event E 354 Failure To Communicate 000
FTC Restoral R 354 Failure To Communicate 000
Send over Cellular
If this option is enabled, this device will only communicate via cellular network, effectively putting the
communicator into primary mode. If this option is disabled, the communicator will operate in back-up
mode.
Periodic Reports
This device can be programmed to send periodic Contact ID reports. This section will allows the selection
of the
Date and Time of the first periodic report and the Interval between reports.
Note: If the external power supply (connected to terminals [+12v]) and battery power supply drop
at the same time, the device must be re-programmed after the power supply is restored, other-
wise the time set for the Periodic Report cannot be respected.
Cellular page
This page outlines the cellular configuration options.
Access Point Name (APN)
Enter the Access Point Name of the cellular service provider being used (example: ibox.tim.it). Please
contact the Cellular service provider for this information.
Receiver IP address and Port
Enter the primary (mandatory) and back-up (optional) receiver IP addresses and port numbers. Use the
same IP address and port that is found in the 'Receiver Remote Port' section of the receiver.
APNs User Name and Password
Some providers may require a user name and password to validate communication. If needed, enter this
information here.
DNIS
If required, enter the Dialed Number Identification Service number. This should be the same DNIS