Dru VENTEO, Инструкция по установке и эксплуатации

Страница: 31 / 64

English
INSTRUCTIONS FOR INSTALLATION OPERATING INSTRUCTIONS
Connecting the Receiver
The remote control system comprises a receiver and a
remote control, packed together in one box.The receiver
must be connected to the appliance fitting the batteries.
This is done as follows:
• Take the receiver out of the box.
• Slide the brown plug of the cable onto the receiver circuit
board (fig. 10).
• Connect the white plug to the connector on the gas
control valve.The different sized plugs correspond with
the connector.
• Open the lid.
• Insert 4 penlight batteries (type AA). Make sure they are
the right way round.
• Replace the lid.
• Connect the
thermocouple wiring
(Fig. 23, arrows B)
• Connect the ignition
wiring (Fig. 23, arrow C)
• Place the remote
control receiver in the
tray on the service flap.
• If you are using an
adaptor, connect it to
the unit
(Fig 23, arrow A) and
plug the appliance in.
Replacing the batteries in the receiver
• Open the door from the service flap.
• Take the receiver and open the lid.The batteries are under
that cover.
• Remove the old batteries and insert the new ones, making
sure that the + and – signs on the batteries correspond
with those in the holder.
Inserting or replacing the batteries
in the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
• The temperature is shown on the display in Fahrenheit, press
both buttons for a few seconds and it will change to Celsius.
NB: Do not throw old batteries in the dustbin.
They should be treated as Chemical Waste.
OPERATING INSTRUCTIONS
Remote Control - Igniting
Turn button A anti-clockwise to ON .
At the same time, press and hold buttons and until
you hear a short signal indicating that the ignition process
has begun; now release the buttons.
Continuous signals indicate that the ignition process is
active. A short sound signal (0.2 sec., 1kHz) indicates that
the ignition process has been completed and that there is
sufficient gas flow. Now the appliance will automatically
switch to full load.
Adjustment - Flame Height
In standby mode: Press to increase flame height.
Press to decrease flame height or to set appliance at
pilot flame.
Switching the appliance off
The appliance is switched off using the small ‘off’ button
on your remote control.
“MAN” Mode - Manual Flame Height Adjustment
1. Press to turn on the main burner.
2. Press to increase the flame height.
3. Press to decrease the flame height or to go to pilot
standby position.
NOTE: While pressing either button a symbol indicating
transmission appears on the display.The receiver
confirms transmission with an acoustic signal.
Setting °C/24 hour or °F/12 hour Clock
Press OFF and until display changes from Farenheit/
12 hour clock to Celcius/24 hour clock and vice versa.
Setting the Time
1.The display will flash after either:
a. Installing the battery or
b. Simultaneously pressing the
and .
2. Press to set the hour and the to set the minute.
3. Press OFF to return to manual mode or simply wait
and it will automatically return to the manual mode.
fig. 23
A
B
C
reset
A
fig. 24
B
Venteo
25