6
indicates
the correspondence
between
the transmitter
commands
and the
Connect the power supply and the receiver outputs on the corresponding relay board plug-
in terminals. Do this following the outputs diagram, which is supplied with the set. This
diagram
receiver outputs.
The STOP relays KSTOP1 and KSTOP2 are in series and must be connected
to the main contactor coil circuit.
The K2/START and K12 relays are activated when the start-up command is
held down.
Remember to connect the ground cable.
Only use fireproof cables for connections.
Select the appropriate voltage on the receiver, (230, 115 or 48 Vac)
