23
RECEIVER
In OPERATION mode the 5 LED’s must be lit as has been previously described in section 4.3
Starting. If this is so, press the transmitter motion buttons and observe the response of
the output relays. If the response is normal, the problem is not related to the remote control
equipment and the installation must be checked. If any of the relays is not activated, the
problem is associated with the remote control equipment. If this happens, observe the
appearance of the LED’s:
LED
LIT
FLASHING
OFF
POWER
Power Supply OK
--
Power Supply not OK
HARDOK
Board OK
Fault in the board
Slow: fault in the board
Fast: error in EEPROM
SIGNAL
RF signal OK
RF signal detection in
SCANNING mode
The receiver is not
receiving RF signals
DATA
--
Is receiving the correct
data from a PWRSIII
Signal received is not
correct
ID
--
ID Code OK
ID not recognized
There are also two LEDs in the receiver which will describe the status of the CAN-BUS. If the
CAN connection is not working, check the status of next LEDs:
LED
LIT
FLASHING
OFF
CAN_RUN
Operating status
Pre-operating status
CAN communication non
active
Communication error
CAN_ERR
Communication
CAN controller
OK
disconnected
If the problem is associated with the equipment, please send both the transmitter and the
receiver to the your Technical Assistance Service Agent, together with a description of the
problem and the status of the LED’s.
If the transmitter becomes so damaged that a spare has to be arranged, it can be quickly
substituted by following the instructions in APPENDIX A.
