www.petsafe.net 13
KO
EN
6. Once the Charcoal Filter is rinsed off, place
inside the Base of the Filter Housing with the
larger side facing down. The Charcoal Filter
will only fit inside the Filter Housing Base one
way, if it does not fit, flip it over. Attach the Lid
to the Filter Housing, press down until you hear
it snap in place.
7. Attach the Filter Housing to the Pump by
inserting the raised round notch inside the
circular opening on top of the Pump (
fig. 22
).
The opening on top of the Filter Housing should
be right next to the sealed raised post.
8. Reinsert the Rubber Grommet into the hole at
the top of the Tower. Gently work the Rubber
Grommet into the hole so that the top edge rests
flat inside the dish (
fig. 23
).
9. Align the Tower with the circular indentation
inside the Bowl and carefully lower it until it
rests flat (
fig. 24
). The Rubber Grommet will
create a seal between the Filter Housing and
the Tower.
10. Fill the Pet Fountain by pouring water directly
into the Bowl. Leave at least a 1.27 cm of
space between the water level and the rim of
the Bowl to help control spills and splashing.
11. Place the Pet Fountain in desired location.
Do not pick up a full Pet Fountain by the Tower
piece. To properly pick up the Pet Fountain,
use both hands and grip the sidewalls of the
Bowl and lift.
Important:
To protect your
floor always use a protective mat, such as a
towel or water-resistant placemat. This will
help protect your floor from splashing or spills
caused by your pet.
12. Before you plug in the Pet Fountain, make sure
the electrical power cord, the adaptor and
your hands are completely dry. Connect the In-
Line Plug and make sure no silver is showing,
then plug the adaptor into a standard electrical
wall outlet.
fig. 22
fig. 23
fig. 24
fig. 20
Cord channel
fig. 21
