www.petsafe.net 13
12 www.petsafe.net
EN
KO
5. Once the Pump is completely disassembled,
you can clean the parts with warm water and
soap. Use a cotton swab or the “motor
brush” from the Drinkwell
®
Cleaning Kit to
clean inside the Pump’s motor cavity and
remove any build-up (
fig. 16
). For added
disinfecting and hard water removal, clean
the Pump’s motor with a diluted white vinegar solution (20% white vinegar and
80% water).
Important:
Be sure to rinse thoroughly with fresh water.
6. Once the parts are clean and well rinsed, you can reassemble the Pump for use.
a) Replace the Impeller.
b) Replace the Stator.
c) Replace the Faceplate.
pet fountain reassembly
1. Place the Foam Filter around the Pump (
fig. 17
).
Take the Bowl and place Pump inside the square
indention. Make sure the circular opening, Pump
Outflow, on top of the Pump is positioned in the
bottom right corner of the square (
fig. 18
).
2. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed
the In-Line Plug of the electrical power cord over
and through the raised post and out the notch in
the base of the Bowl (
fig. 19
).
3. Remove the extra slack from the electrical
power cord and insert the Rubber Cap into the
raised post. Make sure the cord channel on the
Rubber Cap is aligned with the electrical power
cord, then insert your finger into the Rubber Cap
and push all the way down (
fig. 20
).
4. Fold the top of the Rubber Cap over the
raised post to seal off the Bowl
(
fig. 21
).
5. Rinse a new Charcoal Filter thoroughly in
cold water to help remove any excess and
loose charcoal dust.
fig. 16
electrical
power
cord
rests on
top
fig. 17
pump
Outflow
fig. 18
fig. 19
Notch
