www.petsafe.net 7
KO
EN
Operating Instructions
Important:
DO NOT RUN DRY - FOR INDOOR USE ONLY.
1. Carefully remove all the Pet Fountain components
from the packaging and set aside prior to
assembly.
2. As with any electrical device, check the electrical
power cord for any tears or damage before use.
3. Place the Foam Filter around the Pump by inserting
the Pump into the Foam Filter from the top, make
sure the electrical power cord rests
on top of the Foam Filter (
fig.1
).
4. Take the Bowl and place the Pump inside
the square indention. Make sure the circular
opening, Pump Outflow, on top of the Pump
is positioned in the bottom right corner of the
square (
fig. 2
). The Foam Filter will be slightly
compressed between the Pump and the raised
post.
5. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed
the In-Line Plug of the electrical power cord over
and through the raised post and out the notch in
the base of the Bowl (
fig. 3
).
6. Remove the extra slack from the electrical power
cord and insert the Rubber Cap into the raised
post. Make sure the cord channel on the Rubber
Cap is aligned with the electrical power cord,
then insert your finger into the Rubber Cap and
push all the way down (
fig. 4
).
7. Fold the top of the Rubber Cap over the raised
post to seal off the Bowl (
fig. 5
).
electrical
power
cord
rests on
top
fig. 1
pump
Outflow
fig. 2
fig. 3
fig. 4
Cord channel
fig. 5
