38 of 95
Reference Manual ATOM one SSM500
SSD1: H 0(OK), T 21/38/59, L 100
Note:
If you have any doubt about the health of your device please contact the Dream
Chip technical support.
8.28 selftest
Note:
This command is only available in the ATOM one SSM500 in Trigger Mode.
This command performs a short SMART self test of the SSDs and reports the result.
The test will run for approximately
two minutes
. During the test no recording or playback
must be running, if recording or playback are still running the command will fail. To stop
recording and playback see the
rec_stop
and
stop
commands in chapter 17.
The output of this command has the following format:
SSD<num>: <result_text> (<result_code>)
The fields have the following meaning:
Value
Meaning
Description
<num>
ID of the SSD
0 or 1
<result_text>
Test result in user
readable format
If the test did not find any issues the result
is “PASS”, else “FAIL” is reported.
In case one ore both devices did not pass
the test please contact the Dream Chip
technical support.
<result_code>
Test result as an
error code
The error code is 0 if the device passed the
test. In case of an error please report the
error code to the Dream Chip technical
support.
Example output:
SSD0: PASS (0)
SSD1: PASS (0)
8.29 calibration_profile <id>
The ATOM one SSM500 can be shipped with two different IR-cut filters. Depending on the
filter a different calibration profile has to be selected, which can be done with this
command.
Profile ID
Description
0
Profile that matches the original IR-cut filter that was shipped with the first
batch of ATOM one SSM500 cameras.
