59 of 95
Reference Manual ATOM one SSM500
11 Defect Pixel Correction
11.1 dpc <flag>
Enables / Disables deflect pixel correction
Flag
Function
0
No correction
1 (reset)
Correction enabled
11.2 dpc_mode <mode>
Sets defect pixel correction mode.
Mode
Function
0
Table based
1
Auto-detection
2 (reset)
Table based + Auto-detection
11.3 dpc_test_mode <mode>
Sets defect pixel test mode. By default the test mode is disabled. There are two test
modes available: Calibration and Validation.
In Calibration mode the camera will output a black and white image with maximum gain,
which is ideal to detect defect pixels.
In Validation mode the camera will output a black image with white pixels at those
positions where the defect pixel correction is currently correcting pixels. You can then
switch between table based or automatic detection (see
dpc_mode
command) to validate
either functionality.
Mode
Function
0 (reset)
Disabled
1
Calibration
2
Validation
11.4 dpc_level <detection level>
Sets detection mode on defect pixel correction.
Level
Function
0 (reset)
Few defects
1
...
2
...
