- 4 -
1
PRODUCT TECHNICAL SPECIFICATION
1.1
FUNCTION DESCRIPTION
Tank type water heater (the heater hereinafter) is designed for the accumulation heating of service
water by
electric energy. Water is heated by an electric element in an enameled thermally insulated tank at the time
defined by the power supplier. At the time of the heating, the element is controlled by thermostat on which
the desired temperature can be set (ranging from
0 °C
to
77
°C
). Once the selected temperature is reached,
heating interrupts automatically. Water accumulated in the tank is then used for consumption. The tank
keeps constant pressure of water from the water main. If the combination faucet hot water valve is opened,
water from the water supply conduit pressed out by cold water pressure flows out of the heater. Hot water
flows out through the top part, and water flowing in remains in the bottom part of the heater. Pressure
principle allows hot water withdrawal at any place from the heater.
1.2
ADVICE FOR CUSTOMERS
1.2.1
HOT WATER CONSUMPTION
Consumption of hot water in households depends on the number of people, amount of sanitary
equipment, length, diameter, and insulation of piping in the flat, or on individual habits of users.
The cheapest option of water heating comes at the time when the electricity rate is reduced.
Find out in what time intervals your electricity supplier provides reduced tariff and, depending
on that information, select relevant volume and power input of the heater so that your hot
water consumption covered the needs of your household.
1.2.2
ENERGY SAVING
The heater is insulated with quality polyurethane Freon free foam. Set the temperature of the
heater's thermostat to that level only that you need to run your home. Thus you will reduce
electricity consumption, as well as the amount of lime sediments on the walls of the receptacle
and on the electric body.
1.2.3
EMERGENCY POWER CONSUMPTION
According to current legislation, the standby consumption is stated in the value of annual
consumption of electric energy (kWh), which is measured according to the corresponding load
profile and calculated according to the formulas and requirements of EU Regulation
No. 812/2013.
