36 Installation
(for qualified installers only)
© Travis Industries
4140514
100-01374
Steps for Finalizing the Installation
1. Remove the glass frame (see page 38).
NOTE
: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass frame removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3. Install the required firebacks (see page 40).
4. Remove the heat shield from the battery box (remove and discard the lock-tie – see illustration below). Install
the four AA batteries into the battery box (NOTE: the heat shield must be in place whenever the fireplace is in
operation). The AA batteries act as a power backup in case the household (AC) power goes out and are
required for operation. Install three AAA batteries into the remote (see illustration below). Synchronize the
transmitter to the IFC (see the owner’s manual).
5. Make sure the accent light bulbs are in place and work correctly.
NOTE
: Take care to not touch the bulb with your fingers (use a cloth or paper towel).
6. Install the crushed glass (see page 42).
7. Replace the glass frame.
Heat Shield
FUSE
FUSE
Lock-Tie
Battery Box
AAA Battery
AAA Battery
°F
AAA Battery
AA Battery
AA Battery
AA Battery
AA Battery
