Installation
(for qualified installers only)
25
© Travis Industries
4140514
100-01374
Intake Restrictor
The intake restrictor is accessed by removing the burner (see LP Conversion Instructions on page 43 for details).
The intake restrictor is shipped in the open position (position # 1). Follow the directions below to change the
intake restrictor to position # 2 or # 3.
Position # 1 (stock - open)
Position # 2
Loosen the three screws
shown to the right (1/4”
nutdriver). Then slide the
restrictor down and re-
tighten the screws.
The intake restrictor is
located behind the burner,
on the rear wall of the
firebox.
Position # 3
Follow the directions above
for position # 2. Then
loosen the four nuts shown
to the right (11/32”
nutdriver). Then slide the
restrictor extension down
and re-tighten the nuts.
