User Manual for LoRaWAN End Nodes - CPL01 LoRaWAN Outdoor Pulse/Contact Sensor
1.7 Pin Definitions and Switch
1.7.1 Pin Definition
CPL01 is pre-configured to connect to two external wires. The other pins are not used. If user wants to know more
about other pins, please refer to the user manual of LSN50v2 at:
http://www.dragino.com/downloads/index.php?
1.7.2 Jumper JP2(Power ON/OFF)
Power on Device when putting this jumper.
1.7.3 BOOT MODE / SW1
1) ISP: upgrade mode, device won't have any signal in this mode. but ready for upgrade firmware. LED won't work.
Firmware won’t run.
2) Flash: work mode, the device starts to work and send out console output for further debug
1.7.4 Reset Button
Press to reboot the device.
1.7.5 LED
It will flash:
1. Boot the device in flash mode
2. Send an uplink packet
Page 7 / 32 - last modified by Xiaoling on 2022/07/01 18:01