DR PRO MAX450, Руководство по безопасности и эксплуатации

Страница: 17 / 52

CONTACT US AT
www.DRpower.com
17
Assembling the Collector
(Use Product Package Hardware, see Figure 4 and Knob Set, see Figure 5)
Tools Needed:
•
Two 1/2" Wrenches
1. Stand at the right hand side of the machine ( Figure 16 ).
2. Unfold the fabric Enclosure partially as shown and place it onto the Collector
base.
3. Position the Enclosure with the left side facing up and Enclosure Sleeve
located under front fabric at the front right corner (See Note below).
Note:
Standing at the right side of the machine as shown, the DR Logo will be
upside down and the top flap of the Enclosure is towards you.
4. Position a Collector Tube with the Shorter Leg facing the front of the
machine and insert the ends into the corner loop openings (
Figure 17 ).
5. Push the Tubes all the way through the other end of the loops, exposing the
mounting holes at the Tube ends (
Figure 18 ).
6. Flip the Enclosure over (side to side) so the other side is facing up.
7. Stand at the left hand side of the machine (
Figure 19
).
8. Position the other Collector Tube with the Shorter Leg facing the front of the
machine and insert the ends into the corner loop openings.
9. Push the Tubes through the other end of the loops, exposing the mounting
holes at the Tube ends (
Figure 20 ).
10. Go to the right side of the machine where the Tube ends are located.
Figure 18
Tube
End
Figure 16
Enclosure
Sleeve
Fabric
Enclosure
Collector Base
DR Logo
Front Right
Side Corner
Top Flap
Velcro
Collector
Tube
Figure 19
Left Side
of
Machine
Loop
Opening
Shorter Leg
Loop
Opening
Collector
Tube
Figure 17
Right Side
of Machine
Loop
Opening
Shorter Leg
Loop
Opening
Both Tubes
Installed
Figure 20
Tube Ends