DR PRO MAX450, Руководство по безопасности и эксплуатации

Страница: 23 / 52

CONTACT US AT
www.DRpower.com
23
Installing the Inlet Hose
Tools Needed:
•
Wire Cutters
•
Black Marker
•
Utility Knife
•
Flat Head Screwdriver or 7mm Wrench
1. Observe the location of the two Bridge Hose Clamps near the Coupling end
of the Hose Assembly (
Figure 50 ).
2. Cut the black Spiral Rib of the Hose between the two clamps using Wire
Cutters (
Figure 51 ). Do not cut the clear area of the Hose yet.
3. Mark the path where you will cut the clear Hose using the black Marker to
ensure that the cut will meet at the opposite side.
4. Cut the clear area Hose where you marked using the Utility Knife to separate
the short Hose/Coupling section from the longer Hose/Cuff section.
5. Flip the Hose/Coupling section around so the Coupling is facing the longer
section of Hose (
Figure 52 ). Loosen the Hose Bridge Clamp at the end of the
longer Hose using a Flat Head Screwdriver or 7mm Wrench. Slide the
Coupling into the Hose until the Clamp is just past the Rivet.
6. Tighten the Bridge Hose Clamp onto the coupling using a Flat Head
Screwdrive or 7mm Wrench.
7. Using a Flat Head Screwdriver or 7mm Wrench, loosen the Hose Bridge
Clamp on the end of the Hose. Slide the Hose onto the Housing neck and
tighten the Hose Bridge Clamp (
Figure 53 ).
Inlet Hose
Figure53
Bridge Over
Hose Rib
Hose Bridge
Clamp
Retaining
Bump
Clamp
Area
Bridge Clamp
Figure 52
Coupling
Rivet
Figure 51
Wire Cutter Cut
Point (black Rib)
Knife Cut Line
(clear plastic)
Coupling
Figure 50
Bridge Hose
Clamps