Revision 1.3
Revision Date 1/28/2020
Turbonator® VGT Controller
www.dieselpowersource.com
Exhaust Brake Wiring
1998.5-2002 Dodge 5.9 VP44
______________________________________________________________________
1. Locate the ECM on the drivers side of the engine, remove bolt, disconnect the connector
from the ECM.
2. On the inside of the plug at pin 20 there is a small piece of plastic to keep water out.
Use needle nose pliers and pull the plastic piece out.
3. Push the Yellow single wire into the plug from the wire side, until it clicks.
4. Plug connector back into the ECM and tighten bolt.
