Revision 1.3
Revision Date 1/28/2020
Turbonator® VGT Controller
www.dieselpowersource.com
Exhaust Brake Wiring
6.7 2007.5-2018 (Do not connect to indicated pin)
_____________________________________________________________________
1. Connect the single yellow wire shown in figure 5, labeled PIN 20 into the wiring harness.
2. Run the wire end on the yellow wire into the cab.
3. Locate the factory Accelerator Pedal Position (APP) plug located just above the
accelerator pedal.
4. Unplug the factory APP connector by pressing the release button.
5. Carefully peel back the protective sheathing to expose about 1½ inch of wires. If using a
razor blade be very careful to not cut into the insulation on the individual wires.
6. On the factory APP plug, locate the factory
Brown/Light Green wire
, and use the
provided wire tap to crimp into that wire.
7. Connect the yellow wire labeled PIN 20 to the wire tap.
8. Plug the factory connector back into the APP.
