Revision 1.3
Revision Date 1/28/2020
Turbonator® VGT Controller
www.dieselpowersource.com
Exhaust Brake Wiring
2003-2007 Dodge 5.9 Common Rail
____________________________________________________________________________
1. Locate the wires shown in Figure 4, which have the relay and two loose wires, with PIN
labels.
2. Locate the ECM on the drivers side of the engine, remove bolt, disconnect the connector
from the ECM, which contains the pins shown on the provided wires.
3. On the inside of the plug at the pin location there is a small piece of plastic to keep water
out. Use needle nose pliers and pull the plastic piece out.
4. Push the two new pins into the connector until they click.
5. Plug connector back into the ECM and tighten bolt.
