T
RITON
S
YSTEMS
9640-
TO
-9600
C
ONVERSION
P
ROCEDURE
8
4.
Install the slide tray by carefully aligning the ends of
the left and right inner slides on the tray with the
corresponding slots on the cabinet rails.
When the left and right slides are lined up, slowly
push the slides into the outer rails. Continue pushing
until you reach the rail stops. The tray should be
completely within the security cabinet enclosure.
Push inner slides into cabinet rails.
Slide Tray installed. Shown in operating
position
Align left and right inner slide ends with
slots on cabinet rails.
2.
Pull each slide forward to remove any play within the
mounting holes. Tighten the screws firmly to secure
each slide member.
3.
In the security cabinet, grasp the outer slide members
and pull them out to the fully extended position.
Use a nutdriver and a Phillips
screwdriver to attach the inner slide
members to the SDD Dispenser Tray.
Insert screws from this side.
Use nuts to secure screws
Pull each slide forward before
tightening screws.
Pull outer slide members to fully
extended position.
