T
RITON
S
YSTEMS
7
9640-
TO
-9600
C
ONVERSION
P
ROCEDURE
10. Connect the EJ-to-Mech Dispenser Cable (09600-
00027) to the Electronic Journal. Route the cable
through the cable clips.
INSTALL 9600 DISPENSER SLIDE TRAY
The SDD slide tray has three sets of holes: Top, Middle
and Bottom. Based on the dispenser type, you will use
either the Top or Middle holes to attach the slide
members, as indicated:
1.
IMPORTANT: APPLY A SMALL AMOUNT OF
THREAD LOCK COMPOUND TO THE TIP OF EACH
SLIDE MOUNTING SCREW!
Attach an inner slide member (removed from the 9640
dispenser in a previous step) to the SDD dispenser
slide tray (03011-00434), using three included screws
(02054-00048) and nuts (02301-00040). DO NOT
TIGHTEN THE SCREWS AT THIS TIME! Repeat for
the other slide member.
•
For older-style SDD dispensers, use the top set
of holes!
•
For newer-style SDD dispensers, use the middle
set of holes!
Connect EJ-to-Mech data cable to the
Electronic Journal.
Route EJ-to-Mech data cable through
cable clips.
For older-style mechs, attach slide
using TOP set of holes. For newer
mechs, use MIDDLE holes.
TOP set of holes for older mechs.
MIDDLE set of holes for newer mechs.
