Rack Monitor 8800E/8801E
Document: Installation Manual
Date:
24 August 2016
Version: B.1
Page 28 of 29
Document: H71342
Annex A
-
Available detail wiring drawings of the Rack Monitor
8800E/8801E and associated parts
-
Drawing(s)
DS00257
RS-485 WIRING DIAGRAM
DS00258
BLACK PLUG WIRING
DS00259
7511E DUAL BREAK AWAY
Annex B
-
Modification Mounting Holes
The Rack Monitor 8800E/8801E is equipped with 4 mounting
holes. The Bolts, Washers and Nuts are supplied to you with
the purchase of this product. If it is not possible to apply this
bolts and nuts, the bottom side of the enclosure may be
modified.
The bottom side of the enclosure can be modified by applying
screw thread to the existing mounting holes (Figure 26 section
B-B). The mounting hole can be adjusted to M10 and a depth
of approximately 20mm. This can be applied to all 4 mounting
holes.
Warning: Do NOT change the mounting holes in any other way
then mentioned before and as can be seen in de
corresponding figures on this page or else all guarantees will
be declined.
Make sure that the M10 bolt used to mount the
Rack Monitor 8800E/8801E from the rear is
mounted into to hole at least 1.5 times the
diameter of the M10 bolt.
Figure 23
Figure 24
