Douglas Dynamics SnowEx Liqui Maxx, Руководство пользователя и инструкции по установке, Страница: 12 / 40

Lit. No. 76348, Rev. 01 12 May 15, 2017
4. Connect the harness and the control power cable
to the back of the control and mount the control in
a suitable location within easy reach of the vehicle
operator without restricting access to the vehicle
controls and instruments.
5. Connect the harness to the battery. Refer to the
wiring diagrams for battery connections.
INSTALLATION INSTRUCTIONS
CONTROL BOX MOUNTING
NOTE: Use dielectric grease to prevent corrosion
on all connections.
Before beginning the installation, remove all battery
cables from the vehicle battery terminals.
1. Route the control box harness along the vehicle
frame. Do not route it close to the exhaust system
or engine, where extreme heat could melt the
wiring insulation and short out the sprayer and
vehicle electrical systems. Attach the harness to
frame holes and frame supports. Do not attach
to fuel or brake lines. Use heavy duty cable ties
or frame clamps to fasten the harness along the
frame.
2. Lay out the control power cable along the fire
wall and fender well. Do not connect the power
leads to the battery yet.
3. Route the control power cable and harness using
an existing access hole through the fire wall
into the vehicle cab. If adding an access hole is
necessary, check the area on the other side of the
fire wall to make sure you will not drill into vehicle
wiring or other components.
CAUTION
Before drilling holes, check to see that no
vehicle wiring or other components could be
damaged.
WARNING
Do not install the control for this product in
the deployment path of an air bag. Refer to
vehicle manufacturer's manual for air bag
deployment area(s).
CAUTION
Do not mount the control close to any heater
vents or in areas prohibited by the vehicle
manufacturer for crashworthiness. See
the vehicles body builder's book, owner's
manual, or service manual for details.
CAUTION
Do not alter, modify, or install component in
shaded areas shown below. Failure to comply
may interfere with airbag deployment or
cause injury to operator in an accident.