Dot Hill Systems SANnet II 200, Инструкция по установке, эксплуатации и обслуживанию

Страница: 61 / 186

Chapter 4 Connecting Your SCSI Array 4-29
1. To access the RAID array over an Ethernet connection, first connect the RAID array’s
Ethernet port on each controller to the network.
Note –
SANnet II family arrays require at least CAT-5 Ethernet cable.
Note –
In a dual-controller RAID array, be sure to connect both Ethernet ports to the
network. This provides failover if one controller fails.
2. Establish the IP address of the RAID array, as described in “Establishing
Communications With An Array” on page 4-25.
3. To use the firmware application program from the host server, connect to the IP
address of the RAID array controller with the following command:
Note –
Alternatively, you can use the Solaris operating system
tip
command or a
terminal emulation program to access the firmware application program. See
“Configuring a Host COM Port to Connect to a RAID Array” on page 4-26 for more
information.
4. Press Ctrl-L to refresh the screen and view the Main Menu.
Note –
If you reset the controller during a
telnet
session, you are disconnected from
the RAID array. Use the
telnet
command to login to the array again.
To connect the SANscape program (on a host server) to a RAID array that has an IP
address, refer to the out-of-band management instructions in the
SANscape User’s
Guide.
The same document’s “Email and SNMP” appendix provides information about
configuring SANscape software to use Simple Network Management Protocol (SNMP)
traps and Management Information Bases (MIBs) to provide information to other out-
of-band enterprise management software. The “Monitoring the Array” chapter explains
the use of SANscape agents to redirect event messages into host system logs.
You can also enable the controller firmware to send event messages using SNMP.
Refer to the “Configuration Parameters” chapter in the
SANnet II Family RAID
Firmware User’s Guide for more information.
# telnet
IP-address