Dot Hill Systems SANnet II 200, Инструкция по установке, эксплуатации и обслуживанию

Страница: 129 / 186

Appendix B Cabling JBODs B-19
Figure B-11 JBOD or Expansion Unit Troubleshooting Flowchart, 4 of 4
I/O
Time Out
Error
message
2
Yes
Replace
I/O module.
Resolved?
End
Yes
No
Check for
proper
cabling.
1
Reseat
drives.
Resolved?
End
Yes
Resolved?
End
Yes
No
Replace
drives with
known good
drive.
Resolved?
End
Yes
No
No
7D
JBOD or Expansion Unit Problem (SCSI)
Check for
proper
cabling.
1
Notes:
1. When checking the cabling, look for bent pins, loose wires, loose cable shielding,
or loose cable casing.
2. View this error in SANscape, message file (or event viewer), the event log,
or in the firmware application.
Prior to replacing a chassis, try the following:
--Reseat the FRU that is not operating correctly.
--Swap the questionable FRU with a known-good FRU from the same array.
End