Dot Hill Systems SANnet II 200, Инструкция по установке, эксплуатации и обслуживанию

Страница: 22 / 186

2-2 SANnet II 200 SCSI Array Installation, Operation, and Service Manual • June 2005
The customer is responsible for meeting all government codes and regulations
concerning facilities. The customer is also responsible for compliance with the
following requirements:
■
Meet all local, national, and international codes covered in this specification. The
subjects covered include fire and safety, building, and electrical codes.
■
Document and inform Dot Hill of any deviations from this specification.
2.2 Safety Precautions
For your protection, observe the following safety precautions when setting up your
equipment:
■
Follow all safety precautions and requirements specified in the SANnet II Family
Safety, Regulatory, and Compliance Manual.
■
A fully loaded array weighs over 57 pounds (26 kilograms). Use two people to lift
the array to avoid injury.
■
Follow all cautions and instructions marked on the equipment.
■
Ensure that the voltage and frequency of your power source match the voltage and
frequency inscribed on the equipment’s electrical rating label.
■
Never push objects of any kind through openings in the equipment. Dangerous
voltages may be present. Conductive foreign objects could produce a short circuit
that could cause fire, electric shock, or damage to your equipment.
■
To reduce the risk of electric shock, do not plug Dot Hill products into any other
type of power system. Dot Hill products are designed to work with single-phase
power systems having a grounded neutral conductor. Contact your facilities manager
or a qualified electrician if you are not sure what type of power is supplied to your
building.
■
Your Dot Hill product is shipped with a grounding-type (three-wire) power cord. To
reduce the risk of electric shock, always plug the cord into a grounded power outlet.
■
Do not use household extension cords with your Dot Hill product. Not all power
cords have the same current ratings. Household extension cords do not have
overload protection and are not meant for use with computer systems.
■
Do not block or cover the openings of your Dot Hill product. Never place a Dot Hill
product near a radiator or heat register. Failure to follow these guidelines can cause
overheating and affect the reliability of your Dot Hill product.