Dot Hill Systems SANnet II 200, Инструкция по установке, эксплуатации и обслуживанию

Страница: 179 / 186

J-1
APPE NDIX
J
Revision History
This revision history shows changes to the SANnet II 200 SCSI Array Installation,
Operation, and Service Manual since the previous revision (part number 83-00002359,
rev B).
Page Reference Description of Change
“Checking the
SANnet II 200
SCSI Array
Package Contents”
on page 3-2
“Connecting the
Chassis to an AC
Power Outlet” on
page 4-5
Added the following caution in chapters 3 and 4: “The power
cables for SANnet II products are designed only for SANnet II
products and should not be used with other equipment.”
“Scanning Drives”
on page 6-1 Removed statement in section 2.2.5 that CLI does not have a
command that can force the scanning of a SCSI drive. CLI now
supports the “scan disk” command.
“Drive LEDs” on
page 7-9 Removed steps in the Drive LEDs section explaining how to
disable the periodic drive check time. Modified caution in Drive
LEDs section per engineering request.
“Drive LEDs
Flowchart, 1 of 3”
on page 7-11 Modified Figure 7-4 per engineering request. Added the
following note: “In a single-bus configuration, the replaced
drive LED is amber until “scan disk” is performed.”