DÖRR EcoGun AS AUTO, Руководство по эксплуатации, Страница: 8 / 40

4 Assembly
4.1 Requirements for the
Installation point.
It must be possible to disconnect the
compressed air supply and material feed
to the spray gun and secure it against
reconnection.
Lines, seals and screw connections must
be designed to conform to the spray gun
requirements
Ä
10.5 “Operating values”.
A fastening device capable of securing
the spray gun is required.
The control air supply must be adjustable.
4.2 Assembly
Stationary assembly
Personnel:
Operator
+ additional qualification explosion pro-
tection
Protective equipment:
Protective workwear
Protective gloves
Observe the following at assembly:
Bore of the retaining bolt: 10 mm
Nominal diameters:
Ä 10.2 “Connections”
1.
WARNING!
Sources of ignition may cause explo-
sions!
Ensure a non-explosive atmosphere.
Fig. 2: Assembly
2. Loosen screw (1) using a hexagon socket
screwdriver.
3. Slide the spray gun with the bore of the
fastening bolt (4) onto the support
bracket.
4. Tighten screw (1) using a hexagon socket
screwdriver.
5. Loosen locknut (3).
6. Set orientation angle by using angular
gage (2).
Alignment is not important. Dis-
tance to the work piece: 15 to
25 cm.
7. Tighten the locknut (3).
Assembly
06/2018 EcoGun AS AUTO - MSG00019EN 8/40