DÖRR EcoGun AS AUTO, Руководство по эксплуатации, Страница: 19 / 40

Fault description Cause Remedy
Reduce spraying air pressure (A).
Material too thin.
Change material consistency.
Horn air pressure too
high
Raise horn air pressure using the horn air
control (F).
Cone-shaped spray
jet Bores in air cap are
soiled.
Clean and check air cap Ä 7.2 “Cleaning”.
Replace air cap if defective Ä 8.3.1
“Replace needle and nozzle.”.
Nozzle soiled or defec-
tive.
Clean and check the nozzle
Ä
7.2
“Cleaning”. If nozzle is defective, replace it
along with the needle Ä 8.3.1 “Replace
needle and nozzle.”.
Sickle-shaped spray
jet Bores in air cap are
soiled. Clean and check air cap Ä 7.2 “Cleaning”.
Replace air cap if defective Ä 8.3.1
“Replace needle and nozzle.”.
Nozzle soiled or defec-
tive. Clean and check the nozzle Ä 7.2
“Cleaning”. If nozzle is defective, replace it
along with the needle Ä 8.3.1 “Replace
needle and nozzle.”.
Cap nut or nozzle is
not properly tightened.
Tighten cap nut and nozzle.
Uneven spray jet Nozzle soiled or defec-
tive. Clean and check the nozzle Ä 7.2
“Cleaning”. If nozzle is defective, replace it
along with the needle Ä 8.3.1 “Replace
needle and nozzle.”.
Material pressure too
low. Increase material pressure.
Feed line pinched or
broken.
Check the feed line.
Needle does not close
correctly.
Check control air.
Check operation of needle. Replace
needle, if defective, together with the
nozzle Ä 8.3.1 “Replace needle and
nozzle.”.
Cap nut or nozzle is
not properly tightened.
Tighten cap nut and nozzle.
Faults
06/2018 EcoGun AS AUTO - MSG00019EN 19/40