DÖRR EcoGun AS AUTO, Руководство по эксплуатации, Страница: 4 / 40

1 Product overview
1.1 Overview
Fig. 1: Product Overview
1 Leakage groove
2 Material flow control
3 Control air connection (C)
4 Spraying air connection (A)
5 Retaining bolt with angular gage
6 Material connection for paint circulation
mode
7 Housing
8 Cap nut
9 Air cap
10 Material connection (M)
11 Connector
12 Atomizer air control (R)
13 Horn air control (F)
1.2 Short description
The spray gun is intended for surface
coating. Compressed air is used to apply
material. The coating material is fed through
lines. The operation can be done with paint
circulation or tap line.
Use a suitable nozzle set with air cap,
depending on the requirement Ä 6.3
“Selecting air cap”.
The following factors influence the spray jet
and therefore the result
Alignment of the air cap
The alignment of the air cap determines
the alignment of the spray jet.
Atomizer air pressure
The higher the atomizer air pressure, the
higher the atomizing and the finer the
spray jet
Horn air pressure
The higher the horn air pressure, the
more oval is the spray jet.
Control air pressure
Opens the needle and controls the mate-
rial outflow.
Material pressure
The higher the material pressure, the
higher the material flow
Product overview
06/2018 EcoGun AS AUTO - MSG00019EN 4/40