DÖRR EcoGun AS AUTO, Руководство по эксплуатации, Страница: 10 / 40

You can rotate the air cap (2) to any position
to change the alignment of the spray jet.
1. Loosen the cap nut (1).
Fig. 5: Air cap alignment
2. Rotate air cap (2) in the required position.
3. Hand tighten the cap nut (1).
5 Commissioning
Personnel:
Operator
+ additional qualification explosion pro-
tection
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
Depending on the design of the application
system, two technicians must be present to
execute the commissioning.
Technician 1: Operates the controls
Technician 2: Check on the spray gun.
1. Actuate the spray gun without material
via the control unit or the visualizer.
2. Check the switching behavior.
Does the needle open and close as
required?
Are all types of air supply connected?
3. Rinse spray gun.
Ä 6.4 “Rinsing”
4. Connect material.
5. Create a trial spray pattern on a test work
piece.
Setting the spray pattern
Personnel:
Operator
+ additional qualification explosion pro-
tection
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
You can adjust the spray pattern continu-
ously between round and flat.
Commissioning
06/2018 EcoGun AS AUTO - MSG00019EN 10/40