Dorner 62M005ESBDDEN, Инструкция по установке, эксплуатации и запасным частям

Страница: 12 / 20

Dorner Mfg. Corp. 12 851-738 Rev. A
Brushless DC Motor Control
Installation
External Input Signals
External input signals must be set in accordance with the desired application.
Perform the various settings specified below using the digital operator.
Input Signal Connection Terminals
Connect the input signals according to the operation method of your system. Dry contact signals are recommended. For solid
state signals see Oriental Manual for details.
Figure 23
Figure 23
Application Necessary settings
Use input signals connected to terminals
X1, X2 and X3
Switch the operation-signal input method to “external input signals” on the
digital operator. See
“Switching the Signal Method to Remote Signal (If Required)”
on page 17
.
Terminal
Position
Terminal
Name
Signal Name Description Necessary settings
Lower
Stage
C0 IN-COM0 Input signal common Remove the short bar and connect an
external control equipment.
C1 IN-COM0 Input signal common -
X1 CW input Clockwise rotation Set the operation-signal input method to
“external input signals” on the digital
operator.
X2 CCW input Counterclockwise rotation
TH TH M0 M1 M2 VH VM VL Y1 Y2
X0
Upper stage
Lower stage C0 C1 X1 X2 X3 X4 X5 Y0 C2
Input signal common
ON: Clockwise rotation
OFF: Stop
ON: Counterclockwise rotation
OFF: Stop
Jumper X3 to Common
C3
Input signal
common (0 V)