V. NORMAL MODE ACCESSORY FUNCTIONS
2. System Reset Function
The monitor can be reset to the factory defaults in one easy step. This will erase all of the serial
numbers from the memory of the monitor and will then need to be re-programmed in order for the
monitor to read the sensor signals.
Be sure this is what you want to do before you proceed.
Press and hold the PROG button for 30 seconds. This will erase all sensor
information and return the monitor to its factory defaults.
3. Stored Alarm Information
The Doran 360RV has the ability to store the last 10
alarm faults that have occurred. They cannot be
erased; they can only be replaced by newer, more
recent alarms. This can be useful if a history of
alarms is necessary. It is unlikely that the typical RV
enthusiast will require this feature. Monitoring the
faults and when they occur can be a useful tool for the
over the road trucking industry.
To enter this function, press the PROG and SET
buttons together for 3 seconds. A number 1 will be
displayed on the screen (
see Figure 6-1
). If no other
buttons are pressed within 1 second the monitor will
automatically start to show the last alarm and then will
show up to the last ten alarms that have occurred
from the most recent to the oldest. If you press the
SET button as soon as you enter this mode you can
select the alarm of your choosing by using the left and
right arrow buttons to select a fault number. Each
fault display will last 3 seconds and then there will be
a
second pause between each display until the SET
button is pressed to display the next alarm.
½
Figure 6-2
Figure 6-1
Figure 6-3
Figure 6-4
20
