V. NORMAL MODE ACCESSORY FUNCTIONS
19
1. Drop and Hook Feature
This feature allows the operator of the vehicle to drop the monitoring of either the front or the rear
vehicle allowing the monitor to only receive the RF signals from the vehicle that is in close
proximity to the monitor. The operator can drop the trailer and still monitor the car or truck when
trips are required without the trailer. The operator of an RV can drop the tow car if it is not
required. The process is as follows:
1. Press the front and rear arrow buttons together for
3 seconds.
2. All of the programmed wheel positions will be
flashing (
see Figure 5-1
).
3. Press the front or rear button to select the front,
back or both sections for the system to monitor. The
section that is not selected will drop from the screen
(
see Figure 5-2 and
5-3
).
4. When your selection is made press both the front
and rear arrow buttons for 5 seconds and this will
lock your selection into the monitor. You will be able
to monitor the selected wheel positions as you did
when the system was fully operational. The monitor
will go into the normal operation mode displaying
ON
and the green light will be on if the signals
have been received and they are with-in the baseline
air pressure ranges.
5. To change or return to the fully operational monitor
method repeat the previous instructions in this section.
When you change or add a section to the monitor it
can take up to 6 minutes for the monitor to capture all
of the signals that were not previously being
monitored. The monitor will return to the normal
mode when all selected sensors have reported in and
there are no faults.
Figure 5-1
Figure 5-3
Figure 5-2
