NOTE: To enter directly into this program mode you will need
to press the
button for 5 seconds until the
is displayed. Then press the
button
again briefly 3 times to enter this mode (see Figure 2-17 for
screen display).
PROG
PROGRAM
PROG
11
D. Programming the Unit of Measure
Figure 2-17
NOTE:
To skip this section and go directly to the Sensor Deletion mode just press the PROG
button briefly 1 time. The display should look like Figure 2-20. Anytime during this mode you can
escape out to the next program mode by pressing the PROG momentarily.
The next step in the programming mode is to select the unit of
measure for the air pressure. The monitor is set from the
factory to read in PSI (pounds per square inch) this is the
default unit of measure. The monitor is also capable of
displaying the air pressure in BAR and kPa (
see
Figure 2-18
and 19
). If you want the monitor to read in PSI then nothing
needs to be done except to press the PROG button to move
into the next section of the programming mode. To change the
units of measure do the following:
Figure 2-18
Figure 2-19
1. Press the left or right arrow to select the words PSI,
BAR, or Kpa.
2. When you have your selection press the SET
button for three seconds and the selection should
blink twice and the beeper should beep twice to
confirm the selection in the monitors' memory.
3. Press the PROG button to exit this mode and enter
into the Delete Sensor Location mode next. If you
are done with the programming operation you can
press the PROG button for 5 seconds and the
monitor will return to the normal mode of operation.
This can be done in any section of the program mode
when the programming is completed.
II. SETUP AND INSTALLATION
