Doosan G643, Руководство по обслуживанию

Страница: 157 / 260

G643(E) Service Manual Chapter 5. Engine Management System (EMS) 155
CA100 Mixer
The mixer is installed above the throttle body and
meters gaseous fuel into the airstream at a rate that
is proportional to the volumetric flow rate of air. The
ratio between volumetric airflow and volumetric fuel
flow is controlled by the shaping of the mixer fuel
cone and biased by the controllable fuel supply
pressure delivered by the pressure regulator. Fuel
flow must be metered accurately over the full range
of airflows. Pressure drop across the mixer air valve
must be minimized to assure maximum power
output from the engine.
The mixer fuel inlet is fitted with a thermistor-type
temperature sensor. This permits the SECM to
correct fuel pressure to compensate for variations in
fuel temperature. Left uncorrected, fuel temperature
variations can cause significant variations in air fuel
ratio.
A higher flow mixer is required on larger engines. A
lower flow mixer is required on smaller engines.
Figure 7. CA100 Mixer
CA100 Mixer Operation
Vapor propane fuel is supplied to the CA100 mixer
by the N-2007 pressure regulator/converter. The
mixer uses a diaphragm type air valve assembly to
operate a gas-metering valve inside the mixer. The
gas-metering valve is normally closed, requiring a
negative pressure (vacuum) signal from a cranking
or running engine to open. This is the third of the
three safety locks in the MI-07 system. If the engine
stops or is turned off, the air valve assembly closes
the gas-metering valve, stopping fuel flow past the
mixer. The gas-metering valve controls the amount
of fuel to be mixed with the incoming air at the
proper ratio. The air/fuel mixture then travels past
the throttle, through the intake manifold and into the
engine cylinders where it is compressed, ignited and
burned.
Figure 8. CA100 Mixer Attached to Throttle Body
(Refer to Figure 98.)
The air/fuel mixer is mounted in the intake air stream
between the air cleaner and the throttle. The design
of the main body incorporates a cylindrical bore or
mixer bore, fuel inlet (1) and a gas discharge jet (2).
In the center of the main body is the air valve
assembly, which is made up of the air valve (3), the
gas-metering valve (4), and air valve diaphragm (5)
and air valve spring (6). The gas-metering valve is
permanently mounted to the air valve diaphragm
assembly with a face seal mounted between the two
parts.
When the engine is not running this face seal
creates a barrier against the gas discharge jet,
preventing fuel flow with the aid (downward force) of
the air valve spring. When the engine is cranked
over it begins to draw in air, creating a negative
pressure signal. This negative pressure signal is
transmitted through four vacuum ports in the air
valve.
Figure 9. Parts View of CA100 Mixer