Doosan G20 SIIIA, Руководство по эксплуатации и техническому обслуживанию

Страница: 45 / 122

45 G20, 30, 40 SIIIA Operation & Maintenance Manual
STOP/RESET MODE
Note: If a digital input configured to
panel lock
is active, changing module modes will not be possible. Viewing
the instruments and event logs is NOT affected by panel lock.
If the engine does not stop when requested, the FAIL TO STOP alarm is activated (subject to the setting of the
Fail to
Stop timer
). To detect the engine at rest the following must occur:
• Engine speed is zero as detected by the CANbus ECU
• Generator AC Voltage and Frequency must be zero
• Engine Charge Alternator Voltage must be zero
• Oil pressure sensor must indicate low oil pressure
When the engine has stopped, it is possible to send configuration files to the module from DSE Configuration Suite PC
software and to enter the Front Panel Editor to change parameters.
Figure 16
Note: For further details of module configuration, refer to DSE Publication: 057-172 DSE45xx Configuration
Software Manual.
Stop/Reset Mode
is activated by pressing the
Stop/Reset Mode
button.
The
Stop/Reset
icon is displayed to indicate
Stop/Reset Mode
operations.
In
Stop/Reset Mode
, the module removes the generator from load (if necessary) before stopping the
engine if it is already running.
Any latched alarms that have been cleared are reset when
Stop/Reset Mode
is entered.
The engine is not started when in
Stop/Reset
Mode. If remote start signals are given, the input is
ignored until
Auto Mode
is entered.
When left in
Stop/Reset Mode
with no presses of the fascia buttons and configured for 'Power Save
Mode', the module enters Power Save Mode. To 'wake' the module, press any fascia control buttons
or activate Digital lnput A. The same is true for Deep Sleep Mode.