Doosan 10/104, Руководство по эксплуатации и техническому обслуживанию

Страница: 13 / 110

SAFETY 9
7/124 - 10/104, 10/124 - 14/114, 14/84
Materials
The following substances may be produced during the operation of this
machine:
•
brake lining dust
• engine exhaust fumes
AVOID INHALATION
Ensure that adequate ventilation of the cooling system and exhaust
gases is maintained at all times.
The following substances are used in the manufacture of this machine
and
may be hazardous to health if used incorrectly:
• compressor lubricant
• engine lubricant
• preservative grease
• rust preventative
• diesel fuel
• battery electrolyte
AVOID INGESTION, SKIN CONTACT AND INHALATION OF
FUMES.
Should compressor lubricant come into contact with the eyes, then
irrigate with water for at least 5 minutes.
Should compressor lubricant come into contact with the skin, then
wash off immediately.
Consult a physician if large amounts of compressor lubricant are
ingested.
Consult a physician if compressor lubricant is inhaled.
Never give fluids or induce vomiting if the patient is unconscious or
having convulsions.
Safety data sheets for compressor and engine lubricants should be
obtained from the lubricant supplier.
Never operate the engine of this machine inside a building without
adequate ventilation. Avoid breathing exhaust fumes when working on
or near the machine.
This machine may include such materials as oil, diesel fuel, antifreeze,
brake fluid, oil/air filters and batteries which may require proper
disposal when performing maintenance and service tasks. Contact
local authorities for proper disposal of these materials.
Battery
A battery contains sulphuric acid and can give off gases which are
corrosive and potentially explosive. Avoid contact with skin, eyes and
clothing. In case of contact, flush area immediately with water.
DO NOT ATTEMPT TO SLAVE START A FROZEN BATTERY
SINCE THIS MAY CAUSE IT TO EXPLODE.
Exercise extreme caution when using booster battery. To jump battery,
connect ends of one booster cable to the positive (+) terminal of each
battery. Connect one end of other cable to the negative (-) terminal of
the booster battery and other end to a ground connection away from
dead battery (to avoid a spark occurring near any explosive gases that
may be present). After starting unit, always disconnect cables in
reverse order.
Radiator
Hot engine coolant and steam can cause injury. Ensure that the
radiator filler cap is removed with due care and attention.
Do not remove the pressure cap from a HOT radiator. Allow radiator to
cool down before removing pressure cap.
Generator sets
The generator set is designed for safety in use. However, the
responsibility for safe operation rests with those who install, use and
maintain it. The following safety precautions are offered as a guide,
which, if conscientiously followed, will minimise the possibility of
accidents throughout the useful life of this equipment.
Emergency Stop Controls
Important Note:- In addition to the key operated emergency stop
control on the main control panel, a second control is provided at the
socket control panel in the event of electrical hazards associated with
generator operation. Use this second control to immediately isolate all
electrical power to all sockets, then use the key control to stop the
engine.
Operation of the generator must be in accordance with recognised
electrical codes and local health and safety codes.
The generator set should be operated by those who have been trained
in its use and delegated to do so, and who have read and understand
the operator’s manual.
Failure to follow the instructions, procedures
and safety precautions in the manual may increase the possibility of
accidents and injuries.
Do not start the generator set unless it is safe to do so. Do not attempt
to operate the generator set with a known unsafe condition. Fit a
danger notice to the generator set and render it inoperative by
disconnecting the battery and disconnecting all ungrounded
conductors so others who may not know of the unsafe condition will not
attempt to operate it until the condition is corrected.
An earth point is provided beneath the socket outlets.
The generator set should only be used with the earth point connected
directly to the general earth/ground mass. An earth spike kit is
available as an optional extra for this purpose (refer to the
parts
catalogue ).
WARNING: DO NOT OPERATE THE MACHINE UNLESS IT HAS
BEEN SUITABLY EARTHED.
Generator sets must be connected to the load only by trained and
qualified electricians who have been delegated to do so, and when
required by applicable regulations, their work should be inspected, and
accepted by the inspection agency having authority, prior to attempting
to operate the generator set.
Do not make contact with electrically energised parts of the generator
set and/or interconnecting cables or conductors with any part of the
body or with any non-insulated conductive object.
Make sure the generator set is effectively grounded in accordance with
all applicable Regulations prior to attempting to make or break load
connections and prior to attempting operation.
Do not attempt to make or break electrical connections to generator
sets standing in water or on wet ground.
Prior to attempting to make or break electrical connections at the
generator set, stop the engine, disconnect the battery and disconnect
and lock out the ungrounded conductors at the load end.
Keep all parts of the body and any hand-held tools or other conductive
objects, away from exposed live parts of the generator set engine
electrical system. Maintain dry footing, stand on insulating surfaces
and do not contact any other portion of the generator set when making
adjustments or repairs to exposed live parts of the generator set engine
electrical system.
Replace the generator set terminal compartment cover as soon as
connections have been made or broken. Do not operate the generator
set without the terminal cover secured firmly in place.
Close and lock all access doors when the generator set is left
unattended.
Do not use extinguishers intended for Class A or Class B fires on
electrical fires. Use only extinguishers suitable for class
BC or class
ABC fires.