10.2. Heating battery
In the case of electrical heating, clean the accumulated fluff and dust in the battery once every two months
to avoid risks.
In the case of steam heating, clean the accumulated fluff and dust in the filter in the side part of the battery
once every two months to avoid risks. After 3 years, thoroughly clean the battery using compressed air in the
direction opposite to the air. Passing the device through the blades crosswise may damage the blades.
10.3. Air extractor
10.3.1.
Fan blades
Check
once a year
cleaning the fan blades.
Blades and blocked conduits prevent the air from circulating.
A periodic review of the extraction system should be carried out once every month. Verify that the exhaust
duct, screen, etc. they do not accumulate waste.
10.3.2.
Transmission belts
Only for 65 Lb / 80 Lb models.
The correct tightening of the belt must be checked once a year.
If the belt is not tight enough, it might become prematurely worn. If it is too tight, it might
damage the motor or drum shaft bearings.
Contact your technical service to carry out this operation
10.4. Technical service
If you need to contact the technical service or replacement parts, you can send an email to:
11. TROUBLESHOOTING
11.1. Problem-Cause-Solution Table
Problem
Cause
Solution
The dryer does not
start up
Time at 0:
Select a correct time.
Door open
Close the door.
Filter open
Close filter.
No power supply
Check the condition of fuses.
Check mains voltage is correct.
The dryer does not
heat up
Timer is in Cool-down mode Normal operation of the machine. To
return to heating, increase the time.
The heating does not receive
ON signal
Check thermostat / Control electronic
plate.
Check safety thermostat (1).
GAS alarm
Reset alarm (2).
The dryer does not dry
enough
Cycle time insufficient
Increase cycle time.
Insufficient air flow
Clean the fluff filter.
Check that the output pipe is clean and
not blocked.
Clean fan-extractor blades.
Outlet conduit too long.
Check that the room has sufficient fresh
air inlets.
(1) To reset the safety thermostat, remove the black plastic button and press the button on the back
of the machine, and cover again. If the problem occurs again, contact our After Sales service.
44
