Domino Ax Series, Пользовательская документация

Страница: 163 / 167

MAINTENANCE
EPT019297 Issue 1 November 2016 5-17
i-PULSE PRINT HEAD MAINTENANCE
Print Head Cleaning
WARNING: Protective equipment such as gloves and glasses must be worn when
this procedure is carried out. Physical contact with printer ink or
make-up can cause skin or eye damage.
CAUTION: The printer must be switched off before starting this procedure. If the
printer is running whilst this procedure is carried out, wash will enter the
gutter and may cause the viscosity of the ink to thin.
Required tools: T6 Torx Driver.
Clean the print head as follows:
(1) If the printer is on, press and hold the power button for 2 seconds and wait for the
printer to shut down.
(2) Disconnect the power lead from the rear of the printer.
(3) At the print head, remove the holster by pressing in the two holster retaining clips on the
sides of the print head.
(4) Remove the internal cover by gently squeezing in the sides to release the clips and lifting
the lower part away from the print head and gently pulling downwards.
(5) Follow the annotated instructions in the following illustration.
(6) Replace the print head holster.
End of procedure.
Loosen screw and remove the
Charge Electrode. Clean in the
slot with relevant wash, dry using
lint free tissue.
Clean any ink residue from
deflector plates
Clean any ink residue from gutter
area
i-Pulse Print Head Cleaning