Domino Ax Series, Пользовательская документация

Страница: 156 / 167

MAINTENANCE
5-10 EPT019297 Issue 1 November 2016
ITM Replacement
WARNINGS: (1) The printer must be shut down and the power cable must be
disconnected before the ITM can be removed. The ink system is
pressurised. If the printer is not shut down ink will spray out of the
ITM manifold over the person removing the ITM.
(2) Protective equipment such as gloves and glasses must be worn when
this procedure is carried out. Physical contact with printer ink or
make-up can cause skin or eye damage.
CAUTION: Cleanliness is of extreme importance. Ensure debris does not enter the
new ITM or ink block during this process or the printer may become
damaged. Observe good cleanliness procedures at all times.
Notes: (1) Paper towels (or similar) and wash are required for this procedure.
(2) Waste paper towels will be contaminated with chemicals which are hazardous to the
environment. Local waste disposal regulations must be followed to safely dispose of
used paper towels.
(3) The used ITM contains residual chemicals which are hazardous to the environment.
Local waste disposal regulations must be followed to safely dispose of the used ITM.
The main ink and gutter filters are situated in the ITM and are an integral part of the printer’s ink
system. Replacement of these filters therefore occurs automatically during scheduled ITM
replacement.
The messages, ‘The ITM life is soon to expire. Ensure a replacement ITM is available’ and
‘Intelligent Ink System is in depletion mode to prepare for ITM change’ will appear near the end of
the ITM life. Printing will not continue beyond the expiry of the ITM life.
The ink system will automatically run down the level of ink in the ink cartridge to a minimum level,
so it is usual to replace the ink cartridge at the same time.
To replace the ITM:
(1) If the printer is on, press and hold the power button for 2 seconds and wait for the
printer to shut down.
(2) Disconnect the power lead from the rear of the printer.
(3) Open the access door to the printer ink compartment.
(4) If an ink cartridge is attached to the ITM, remove it by twisting the cartridge anti-clockwise
and lifting it out of the printer.