Dometic SPX1200T, Руководство по обслуживанию

Страница: 8 / 8

4445103557 / 2021-08-05/ Page 8 of 8
Sealing in the middle at the bottom
1. Glue the other pcs. of the 13 cm long stripes of the
sealing tape at the EPP part as shown. The overlapping
shall be between 5 and 8 mm and the sealing tape shall
be positioned centered.
2. Fold the sealing tape down and glue it to the EPP part
and the other sealing tape that was glued before.
Caution!
Before gluing check the correct positioning of the
sealing tape. The gluing must be done carefully to
ensure that the gaps are closed, and no water can
splash through.
Sealing of the side walls with the sealing tapes
1. Use 2 pcs. of 3cm long sealing tapes to seal at the sides
of the sheet metal the gap between the plastic part and
the metal sheet as shown.
Caution!
Before gluing check the correct positioning of the
sealing tape. The gluing must be done carefully to
ensure that the gaps are closed, and no water can
splash through.
Sealing of the right side with the last sealing tape
Use 1 pcs. of the 3 cm long sealing tapes to seal the
gap between the sheet metal and the plastic wall at the
right side of the sheet metal.
Caution!
Before gluing check the correct positioning of the
sealing tape. The gluing must be done carefully to
ensure that the gaps are closed, and no water can
splash through.
2. When the sheet metals with the plastic part are
completely sealed follow the working steps on page 1
& 2 in the reverse order and use the new screws to fix
the outer housing.
Caution!
Place the plastic clip with the temperature sensor at the
same position at the evaporator (Page 2).
Make sure the cables do not touch any components on
the control PCB (heat sink, etc.) and that the cable of
the water level switch will not touch the edge of the
sheet metal after reconnection.
Check whether the condensate hose and cables are
routed and fixed at the same (correct) position.
NOTICE: When reassembling the unit make sure that no cables are pinched and all lose parts (cable tie residues, etc.) are removed from the system.
Check the function in a concluding test run.