4445103557 / 2021-08-05/ Page 7 of 8
Sealing with the 2 protruding ends left and right
1.
Glue the protruding ends of the butyl round cord to the
sides of the sheet metal as shown to close the gap in
this area between the sheet metal and the plastic water
basin.
Caution!
Before gluing check the correct orientation of the part
and the positioning of the sealing tape. The gluing must
be done carefully to ensure that the gaps are closed,
and no water can splash through.
Sealing with the 2 pre-glued sealing tapes left and right
1.
Press the sheet metal to the plastic wall, fold down the
sealing tape and glue it to the plastic and EPP part as
shown (at the left and the right side).
Caution!
Before gluing check the correct orientation of the part
and the positioning of the sealing tape. The gluing must
be done carefully to ensure that the gaps are closed,
and no water can splash through.
Sealing in the middle at the top
1.
Glue one of the 13 cm long stripes of the sealing tape
centered at the front of the sheet metal as shown.
Position it at the edge of the bending (yellow arrow).
2.
Press the sheet metal down to the plastic part, fold
down the sealing tape and glue it to the plastic and EPP
part as shown.
Caution!
Before gluing check the correct positioning of the
sealing tape. The gluing must be done carefully to
ensure that the gaps are closed, and no water can
splash through.
