Dometic 9600023490, Инструкция по установке и эксплуатации

Страница: 22 / 228

EN
Installation Skysol Powered Roofblind
22
Key to wiring diagrams
I
7.2 Frame fitting (pre-assembled version)
7.2.1 Frame fitting
A
Proceed as shown (fig.
4
, page 4):
1. Align the blind with the window cut-out and mark where the holes are to be
drilled for the frame.
2. Ensure the frame is square within the recess by using a measuring device.
Measure the outside corner of the frame to the opposite outside corner and
repeat for the other two corners. These measurement should be within
3 mm of each other.
3. Fix the frame with the screws to the ceiling ( 2. ).
Pos. Description
1 Fused 12 V
g
/24 V
g
power supply (fuse rating 2 A for 24 V
g
, 1 A for
12 V
g
)
2 Head rail
3 Head rail motor options
4 External receiver
5 Customer supplied DPDTswitch (double pole, double throw), center off,
latching or momentary, 12/24 V
g
, 3 A)
bk Black
rd Red
gy Gray
wh White
NOTE
• Accessories are available using the separate order form.
• Observe the applicable documents for the controls and the operating ele-
ments.
NOTICE! Risk of damage
• Use packing material where required (fig.
3
, page 4). The side tracks must
be perpendicular to the head rail.
• Use screws and plugs suitable for the wall construction to fix the frame to
the recess. Pre-drill at the marked points.The heads of screws may be no
larger than 6.0 mm in diameter.
• Ensure not to drill through the wall.
• Ensure not to damage the channel in the side tracks.
• Ensure not to leave screws or other debris inside the side tracks as this can
jam the shoes in the tracks and cause the blind to fail.