Dometic GROUP WAECO MagicSpeed MS-BE3, Инструкция по установке и эксплуатации

Страница: 24 / 176

EN
Installing MagicSpeed MagicSpeed Accessory
24
6 Installing MagicSpeed
6.1 Tools required
For installation and assembly you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Electric drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Set of box spanners (fig. 1 5, page 3)
 Measuring ruler (fig. 1 6, page 3)
 Hammer (fig. 1 7, page 3)
 Centre punch (fig. 1 8, page 3)
To establish and test the electrical connection , the following tools are re-
quired:
 Diode test lamp (fig. 1 9, page 3) or voltmeter (fig. 1 10, page 3)
 Insulating tape (fig. 1 12, page 3)
 Sealant
 Cable bushing sleeves (optional)
To fasten the module and the cables , you may need additional screws and
cable binders.
6.2 Mounting the control panel
I
NOTE
When selecting the installation location, observe the following
instructions:
 Make sure the driver does not have to reach through the steering wheel
to use the control element.
 Install the control element
– where it can be safely used at all times,
– on the dashboard or centre panel.