Dometic GROUP WAECO MagicSpeed MS-BE3, Инструкция по установке и эксплуатации

Страница: 21 / 176

EN
MagicSpeed Accessory Safety and installation instructions
21
If you disconnect the negative terminal of the battery, all data stored in the
volatile memories will be lost.
 The following data must be set again, depending on the vehicle equip-
ment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following installation instructions:
 Secure the parts installed in the vehicle in such a way that they cannot be-
come loose under any circumstances (sudden braking, accidents) and
cause
injuries to the occupants of the vehicle.
 Secure any parts of the system covered by the bodywork in such a man-
ner that they cannot be come loose or damage other parts and cables or
impair vehicle functions (steering, pedals, etc).
 Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only
be performed by qualified specialists.
 To prevent damage when drilling, make sure there is sufficient space on
the other side for the drill head to come out.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp
or a voltmeter.
Test lamps with an illuminant take up voltages which are too high and
which can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.