Status messages and signal sequence
112
The following status messages and signal sequences apply exclusively
to the terminal devices.
Locking medium is authorised on the Access Manager Terminal (conventional
and
Data on Card):
Possibility A:
The locking medium (conventional or Data on Card) is authorised and does
not participate in the extension of validity:
The changeover contact is activated. In this process, the lower LED (ELS) and
the four LEDs (ENiQ) light up green for the duration of the set contact hold
time and you will hear an audible signal. Signalling occurs on each connected
unit.
Possibility B:
The locking medium (Data on Card) is authorised, participates in the extension
of validity and the programming of the extension has worked: First,
programming of the extension of validity takes place. A purple flashing signal
occurs during programming.
The changeover contact is subsequently activated. In this process, the lower
LED (ELS) and the four LEDs (ENiQ) light up green for the duration of the set
contact hold time and you will hear an audible signal. Signalling occurs on
each connected unit.
Possibility C:
The locking medium (Data on Card) is authorised, participates in the extension
of validity and the extension has not worked: If there is an error during
programming or programming is cancelled, both LEDs (ELS) or all four LEDs
(ENiQ) briefly flash three times and you will hear three audible signals.
In this case, the changeover contact is subsequently not activated and the
locking medium is rejected in the same way as an unauthorised locking
medium. The upper LED (ELS) or all four LEDs (ENiQ) then briefly flash red
twice. The upper red LED (ELS) or all four LEDs (ENiQ) go out once on the
passive reader.
